CAN Sniffer
CAN Sniffer: data sniffer for CAN bus with USB and RS232 interfaces
CAN Sniffer is a control unit which can be interfaced and monitoring a CAN bus by USB (in this case the card is self-powered) or RS232 interfaces. Its configuration is achieved either through USB (in this case the board is self powered) or through RS232 interface. Beside acting as a sniffer while it is connected to a PC, the system can work as a stand-alone device and save till 8.000 CAN messages (1.024 kbit) on its inner non-volatile memory.
Easy to use and to configure, thanks to the provided software.
CAN Sniffer can be immediately used with any CAN BUS, thanks its fully configurability.
Customizable parameters are:
- High-speed / Low-speed.
- Baudrate.
- Address.
This card is manufactured with small and practices size, 100 x 70 mm (3.94 x 2.76 inc), to be easily integrated in several systems.
CAN-Sniffer is provided with a configuration and control software for Windows XP, Vista and 7.
General technical features
Power supply:
- USB mode: self powered through USB
- RS232 mode: 7.5-30 VDC
Working temperature: from 0°C up to +60°C
Storage temperature: from -40°C up to +85°C
Interfaces toward PC: 1 USB port type B, compatible with USB2.0 and RS232
Card dimensions: 160 100 x 70 mm (3,94 x 2,76 inches)
CAN interface:
- Compatible with standard CAN 2.0B Active Specifcation
- Configurable High-speed o Low-speed
- Programmable Baudrate (up to 1MB/s)
- Programmable reception filters (available for extended and standard frame)
- Card insulation (selectable) >1014 Ω
- Maximum applicable voltage (CAN-board): 150VRMS
- Transceiver power supply: 5VDC